Results 1 to 4 of 4

Thread: Thread length and sensors

  
  1. #1
    Status
    Offline
    Keith-n's Avatar
    AOC Newbie
    Join Date
    Sep 2010
    Posts
    31
    Mentioned in
    0 Post(s)
    Quoted
    0 Post(s)

    Thread length and sensors

    Afternoon gents,

    I'm looking for someone with experience for the first one. I'm fitting alloys and a 10mm spacer to my g. The standard bolts are not long enough. The thread length is 20mm. I bought longer ones but they were too long @ 44mm (measured after buying )

    Now obviously shooting between the two would solve the issue but i can still be too long and would rather avoid this.

    So if anyones done this, could you tell me M12x1.5 tapered 17 hex, ??mm thread length.

    Appreciated.

    Secondly, I have an abs light on. I plugged it in and it tells me wheel sensor, front right, bad signal. Can these be bought seperatly? Rough cost? Part number

    Thanks blokes,
    Much appreciated.

    Keith.

  2. #2
    Status
    Offline
    bucky's Avatar
    AOC Obsessed
    Join Date
    May 2005
    Posts
    1,179
    Mentioned in
    0 Post(s)
    Quoted
    0 Post(s)
    more spacers needed.

  3. #3
    Status
    Offline
    Keith-n's Avatar
    AOC Newbie
    Join Date
    Sep 2010
    Posts
    31
    Mentioned in
    0 Post(s)
    Quoted
    0 Post(s)
    Quote Originally Posted by bucky View Post
    more spacers needed.

    More spacers = wheel outside arch

  4. #4
    Status
    Offline
    bucky's Avatar
    AOC Obsessed
    Join Date
    May 2005
    Posts
    1,179
    Mentioned in
    0 Post(s)
    Quoted
    0 Post(s)
    lower more. roll arches.
    job = gud 'un

Similar Threads

  1. Replies: 5
    Last Post: 22-05-2011, 21:11
  2. Length
    By moley_2003 in forum Bodywork and Exterior
    Replies: 5
    Last Post: 19-04-2006, 08:21

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •