Got my HID kit today an ive just been wiring them up so i dont have to stand out in the freezing cold for too long tomorrow.
Following the How to, just a couple of things..
1. WHen it says thread the rubber gromet through the bulb holder and push it up tight to hold everything in place. I did that as said, but it doesnt really hold everything firmly in place. The bulb can still rotate pretty easily. Will it all be firm once its fitted into the headlight itself?
2. WHat position should the bulb itself be in when inserted into the light. Because i looked at the bulb and it has a dark vertical line going from the tip of the bulb to the base. If that makes sense, where should this line be, if say you look directly at the drivers side headlight, at what angle should the line be?
Hope that makes sense