I'm having troubles with my 1.3cdti.
Started with intermittent spanner light, but disappeared upon restarting the engine. Fault codes where 190 and 235 (rail and MAP sensors). I cleaned the map sensor and the car was fine again.
Same happended after a while with the same codes. After a while also codes 100 (MAF), 106 and 108 (MAP/boost codes) showed up. Tried to clean the MAP sensor again, but no luck. Ordered a MAP sensor from vaux world, but the car is still in limp mode and all the 5 codes are still there.
Anyone got a clue? Dodgy sensor from vaux world or other?
Should mention that the 190 code has been there for a while, but not caused any problems.