Im in the middle of replacing the brake lines on the car
ABS pump > front left & front right have already been replaced but the rears are proving a little difficult
Mainly due to a certain cowboy who cut corners last time when he "rebuilt" my car
basically he left the rear bias valve plumbed in, fitted the rear discs etc and then plumbed in the rest of the ABS system so the rear discs were controlled by both ABS pump and the rear bias valve!!!
Thankfully ive ripped all this crap out and running fresh pipes from ABS pump to rear discs......
the front 2 union nuts on the ABS pump are not marked,
i couldnt trace the setup before due to having that gash bias valve plumbed in
2 couplings exist underneath the bulkhead - one male & one female but cant work out which is rear left or right.
Ideally I would replace the unions on the ABS pump itself and fit fresh pipe all the way back, but the pipes to the couplers are in good nick, and access down the bulkhead is more than a little tricky.
Can someone confirm which unions are which on the ABS pump (front 2) as top 4 are 2x feed, and 2x fronts.
confirm which pipe is which on the underside - the male/female coupler.
Any help appreciated guys as id like to get the new pipes fitted today.