Considering this but not sure how easy it is to balls it up.
I wouldn't go the rotary route. I used this on wood & while i can just about get away with it, i wouldn't want to risk it on something 'on show' as bump strips are.
My dad has a RO circular sander & also a rectangular sander. I was considering using the rectangular one as i've had better results (on wood) with that one.
Figure it'd save the arm ache by doing it manually. Just wondered if anyone else has gone the machine route?
Was it a good idea that turned bad? Or did it all pan out well for you?
Just some general feedback would be great. Cheers.