I have a problem with my Heater/Blower. I have read other threads to try and sort the problem but had no luck. I have replaced the Resistor as i read this can be a common fault but still not working. However, there are two wires (red and black i think) that go into the side of the motor casing behind the glovebox. When i pull or wiggle these wires about the blowers start to work. I have tried getting into the casing to take a look but not been able to do so. Anyone know how to get into it or what the problem might be.
I have also taken off what i believe to be the Scuttle panel off and filter for the air inlet (below the wipers) and if i lightly put pressure the motor/fan it beings to work again. Anybody got any ideas.
Thanks in advance.