Results 1 to 4 of 4

Thread: need serious help people wiring loom

  
  1. #1
    Status
    Offline
    bigman88vp's Avatar
    AOC Newbie
    Join Date
    May 2009
    Posts
    36
    Mentioned in
    0 Post(s)
    Quoted
    0 Post(s)

    need serious help people wiring loom

    right i have just got a gsi engine from a safira and putting it in my astra sri 2.0, i need elp witht thw wiring loom and if my loom from my car will work or will i need a full gsi loom for engine bay?

  2. #2
    Status
    Offline
    Joereynolds89's Avatar
    AOC Obsessed
    Join Date
    Jan 2007
    Posts
    2,099
    Mentioned in
    0 Post(s)
    Quoted
    0 Post(s)
    You need the loom and ecu, transponder, and chip also

  3. #3
    Status
    Offline
    gsibell's Avatar
    AOC Regular
    Join Date
    Jul 2009
    Posts
    170
    Mentioned in
    0 Post(s)
    Quoted
    0 Post(s)
    I hope this is of some help as I have done this conversion myself over the last few months,

    You will need:

    Engine box alternater ect ect (full lump basically)

    ECU, Transponder and chip

    Intercooler

    Exhaust of astra gsi (unless you intend getting a milltec or something)

    Full wiring loom from under bonnet (lights etc) this is mainly for water level sensor and washer bottle sensor and maybe other things just best to replace.

    Engine wiring that should be attached to your engine goes to starter motor etc

    Dash loom (if you dont have fly by throttle)

    gearstick and cable linkage

    Stalks for C/C and trip computer and clutch switch to allow C/C to work

    Bigger screen for dash display if your car doesnt already have trip computer

    This is what i needed for my 2,0 astra sri 1999 there maybe things ive missed but sure thats about it NOT CHEAP lol

    GOOD LUCK

  4. #4
    Status
    Offline
    gsibell's Avatar
    AOC Regular
    Join Date
    Jul 2009
    Posts
    170
    Mentioned in
    0 Post(s)
    Quoted
    0 Post(s)
    Quote Originally Posted by bigman88vp
    Yeah the engine I have got is out of a saf gsi, so is the. Wiring loom the same or will I need a dash and engine loom from an Astra gsi??? My Sri is already linkage my engne goes straight in to the linkage all that's different is the engine loom as m the saf they have xenon lights and loads more stuff but te connector in my Astra is 3 pin and in the saf it's 5 pin were is the beat place to get a loom from???
    Im not 100% what the differance between the looms is my honest advice is to replace them with astra looms even if its just out of a coupe turbo (what i used) as then all the wires and clips will just drop into place beautifully and wires will be tidy.
    Maybe its just me been picky but i hate seeing conversions with wires everywhere they should look original

    Hope this helps

Similar Threads

  1. Wiring Loom Help
    By M1C VX in forum Electrical
    Replies: 3
    Last Post: 02-12-2006, 12:35

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •