I am going to be replacing my sink and bath taps in the next few weeks so doing my homework now.
My sink taps I am fine with as they are just 15mm pipe onto the tails that come out the mono mixer tap.
Its the bath taps I am unsure about as they have normal connections. I am going to be buying some flexi tails that will bolt onto the tap but unsure what size they are. Options I have are 1/2" or 3/4". I take it I need the 3/4"?
Also everywhere I seem to read on the net says they should be feed by 22mm pipe. At the moment my cold feed is 15mm and the hot is 22m thats been reduced to 15mm just before the old tap.
So is it ok to just use the pipework thats there and just fit 2 flexi tails to the 15mm feeds and then onto the taps whech I think are 3/4"?