Results 1 to 3 of 3

Thread: torque setting

  
  1. #1
    Status
    Offline
    bloopeta's Avatar
    AOC Fanatic
    Join Date
    Apr 2007
    Posts
    659
    Mentioned in
    0 Post(s)
    Quoted
    31 Post(s)

    torque setting

    this may be wrong section but I wasnt sure where it would fall under so please move if needed.

    Whats the torque setting for front hub nut on astra G?? the big one on the end of the driveshaft

  2. #2
    Status
    Offline
    Big Col's Avatar
    AOC Fanatic
    Join Date
    Feb 2004
    Posts
    438
    Mentioned in
    0 Post(s)
    Quoted
    0 Post(s)
    from Haynes manual...

    stage 1...... 120Nm
    stage 2...... Loosen nut fully (until it can be turned by hand)
    stage 3...... 20Nm
    stage 4...... Angle tighten by a further 80° (plus to next split pin hole as necessary)
    Vauxhall history - 13S | 14NV | C16XE | X20XEV

  3. #3
    Status
    Offline
    bloopeta's Avatar
    AOC Fanatic
    Join Date
    Apr 2007
    Posts
    659
    Mentioned in
    0 Post(s)
    Quoted
    31 Post(s)
    thanks m8, much appreciated

Similar Threads

  1. Torque setting needed
    By Nealey in forum NA Engines (Non-turbo petrol) inc. Transmissions
    Replies: 2
    Last Post: 24-02-2012, 19:55
  2. Torque Setting
    By llihzag in forum NA Engines (Non-turbo petrol) inc. Transmissions
    Replies: 5
    Last Post: 02-02-2007, 18:38

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •