Results 1 to 2 of 2

Thread: Will This Tower Led Bulb Fit Behind the Speedo Dials and the Heater Unit?

  
  1. #1
    Status
    Offline
    Colonel Deckers's Avatar
    AOC Newbie
    Join Date
    Jun 2008
    Posts
    72
    Mentioned in
    0 Post(s)
    Quoted
    0 Post(s)

    Will This Tower Led Bulb Fit Behind the Speedo Dials and the Heater Unit?

    Good afternoon all.

    Currently i have 3 white Quad bulbs in behind the Speedo / Rev counter and guages. They're ok, but the light source is too visible, they're 5mm by the way.

    The problem is that there are areas of the dials that are alot darker, even though the Quad LED's are flat headed and wide angled and there's even 12 bulbs already in there?

    I was just wondering if these below would be too big to fit in behind the speedo dials, i reckon these would definitely go a long way to eliminate the dark patches that the quad LED's doesn't illuminate that well and i they did fit they might do a crackng job in illuminating the dials.

    Any advice guys?

    http://www.ultraleds.co.uk/501194t10...te-p-1545.html


  2. #2
    Status
    Offline
    Colonel Deckers's Avatar
    AOC Newbie
    Join Date
    Jun 2008
    Posts
    72
    Mentioned in
    0 Post(s)
    Quoted
    0 Post(s)
    Here's a picture to show how the light source is clearly visible.


Similar Threads

  1. Plasma speedo + heater dials & footwell neons
    By amatthews45 in forum Electrical
    Replies: 8
    Last Post: 11-09-2011, 18:13
  2. Replies: 12
    Last Post: 03-02-2007, 09:45

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •