Results 1 to 2 of 2

Thread: Irmscher bonnet extension fitting query

  
  1. #1
    Status
    Offline
    se6's Avatar
    AOC Fanatic
    Join Date
    Jan 2007
    Posts
    775
    Mentioned in
    0 Post(s)
    Quoted
    0 Post(s)

    Irmscher bonnet extension fitting query

    I have an Irmscher bonnet extension i need to get sprayed then i can fit it to my coupe.
    In the fitting instructions it mentions raising the bonnet 2mm, but after searching on here i cannot find any mention of people doing this. So is ths necessary??? After looking around the hinge area i dont think it would be the easiest of things to do.
    Secondly there was a metal strap in the fitting kit, i can't understand what purpose it serves. Any ideas?
    Also any fitting tips at all from people who have done them and can pass on their advice from experience?
    thanks

  2. #2
    Status
    Offline
    f4af100uk's Avatar
    AOC Gold Member
    Join Date
    Mar 2006
    Posts
    6,615
    Mentioned in
    0 Post(s)
    Quoted
    0 Post(s)
    all i did mate is with the bonnet closed i put it in place and made sure the gap was even all round, taped it in place, opened the bonnet and carefully and slowly open the bonnet to make sure it aint gunna hit or rub it, if not then drill the holes and fit the little plastic clips

Similar Threads

  1. irmscher bonnet extension fitting
    By dkbsaxon in forum Bodywork and Exterior
    Replies: 2
    Last Post: 17-02-2012, 21:24
  2. Irmscher bonnet extension fitting help
    By DaveCoupe in forum Astra Discussion & Chat
    Replies: 14
    Last Post: 26-04-2010, 08:10

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •