Results 1 to 3 of 3

Thread: Can some1 help me 4 boot release?

  
  1. #1
    Status
    Offline
    kma_0007's Avatar
    AOC Newbie
    Join Date
    Jun 2006
    Posts
    34
    Mentioned in
    0 Post(s)
    Quoted
    0 Post(s)

    Unhappy Can some1 help me 4 boot release?

    I've fitted my boot release same as member:pardoe16V, but I'm now having problems. Its fitted all but when i press the push to make switch the boot popper just pops open but does not close even i press the button again, but when i switch the wires over (green and blue on popper) and then press the button, it closes but does not open. What is going on? What can be done about this?

    I've had all the following materials:

    boot popper (solenoid)
    cable
    12V automotive 20Amp relay (depending on relay power consumption)
    steel plate
    silversteel bar (typically 2.5mm or 3mm dia)
    daewoo boot latch
    push to make switch
    In line fuse
    15AMP fuse
    KMA
    Kiss My Ass Production

  2. #2
    Status
    Offline
    Nathan_sxi's Avatar
    AOC Fanatic
    Join Date
    May 2007
    Posts
    680
    Mentioned in
    0 Post(s)
    Quoted
    0 Post(s)
    check that the latch spring is strong enough to pull the solenoid back to the origional postion. if not fit a stronger spring.
    The Man with a new Plan

  3. #3
    Status
    Offline
    kma_0007's Avatar
    AOC Newbie
    Join Date
    Jun 2006
    Posts
    34
    Mentioned in
    0 Post(s)
    Quoted
    0 Post(s)
    But it happens without connecting to latch (was trying to test it first before connecting to latch)
    KMA
    Kiss My Ass Production

Similar Threads

  1. Flushing the boot and fitting a boot release
    By AndyJH_Astra in forum Bodywork and Exterior
    Replies: 6
    Last Post: 05-03-2009, 02:32

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •