Couldnt work out which forum to post in so mods use ur discretion!
Right then folks....In the middle of colour coding all the exterior plastics on my motor... no problems at all just a little advice needed.
Do I need to flat the surface after Ive applied the top coat ready for the lacquer???
The How To doesnt say u need to - but the instructions on the lacquer say u do.
The finish is very good so far just dont know if by flatting it to a slight matt appearance then lacquering is the way to do it.
So far only done 2 mirror casings, rear hatch handle thingy and some under bonnet goodies, used 2 cans of top coat already... Bumpstrips are a total ******* to flat so gonna take a little more time than anticipated, then handles & skirts at a later date.
Comments and advice greatly appreciated.